ATC-108A

Products features

• Input of analog load cells:1~3mV/V,300~2000 Ohms
• Device power up to 12 psc 350 Ohms load cells
• Output: standard RS232, can connect to PC direct
• Light insulation type
• Non-linearity compensation
• Filter treatment Exterior led show working order

Dimensions

Work Principle

This is a based weighting solution. It can be used for either analog strict weighing. No need the
indicator, and it has a low cost. Usually, it connects the junction box between the computer.
The signal of some analog load cells will be magnified after analog adding by the junction box,
which will be dealed with by MCU after A/D conversion, then will output to PC by RS232 module.
Please refer to following picture.

Note:
Multi-load cells should connect junction box then connect to ATC-108A.

Communication

The ATC-108A is equipped with standard RS-232 output interface, it can communicate with computer or connect to indicator.
Serial communication baud rate:9600bps,1 bit start bit,8 bit data bit,1 bit stop bit, no parity bit(use
byte verify and mode verify).

STX       n      D        X1      X2     X3      X4      X5     X6      BCC     CR

02H   31H   44H   32H  3CH   35H   32H   30H   38H    32H    0DH